2007 Infiniti M35 Owner's Manual - Page 116

SUNROOF Auto reverse function If the windows do not close automatically If the power window automatic function (closing only) does not operate properly, perform the following procedure to initialize the power window system. 1. Push the ignition switch to the ON position. 2. Open the window more than halfway by operating the power window switch. 3. Pull hold hold after the power window switch and it to close the window, and then the switch more than 3 seconds the window is closed completely. WARNING There are some small distances immediately before the closed position which cannot be detected. Make sure that all passengers have their hands, etc., inside the vehicle before closing the window. If the control unit detects something caught in the window as it is closing, the window will be immediately lowered. The auto reverse function can be activated when the window is closed by automatic operation when the ignition switch is in the ON position or for 45 seconds after the ignition switch is pushed to the LOCK position. Depending on the environment or driving conditions, the auto reverse function may be activated if an impact or load similar to something being caught in the window occurs. WARNING In an accident you could be thrown from the vehicle through an open sunroof. Always use seat belts and child restraints. Do not allow anyone to stand up or extend any portion of their body out of the sunroof opening while the vehicle is in motion or while the sunroof is closing. CAUTION Remove water drops, snow, ice or sand from the sunroof before opening. Do not place any heavy object on the sunroof or surrounding area. 4. Release the power window switch. Operate the window by the automatic function to confirm the initialization is complete. 5. Perform steps 2 through 4 above for other windows. If the power window automatic function does not operate properly after performing the procedure above, have your vehicle checked by an INFINITI dealer. AUTOMATIC SUNROOF The sunroof operates when the ignition switch is in the ON position, or for about 45 seconds after the ignition switch is pushed to the LOCK position. 2-46 Instruments and controls