2009 Infiniti FX50 Owner's Manual - Page 227

iPod® PLAYER OPERATION (if so equipped) Connecting iPod® Open the console lid and connect the cable 1 * as illustrated, and then connect the 2 other end of the cable to your iPod® * . Your vehicle is equipped with the specialized cable for connecting the iPod® to your vehicle audio unit. The battery of your iPod® is charged during the connection to the vehicle. The display on the iPod® shows an INFINITI screen when the connection is completed. While connecting the iPod® to the vehicle, the iPod® can only be operated by the vehicle audio controls. To disconnect the cable from the vehicle outlet, fully depress the center connector button to unlatch the connector and pull the connector straight out of the outlet. To disconnect the cable from the iPod®, fully depress the side connector buttons and pull the iPod® connector straight out of the iPod®. * iPod® is a trademark of Apple Inc., registered in the U.S. and other countries. Compatibility The following models are available: . Third generation iPod® (Firmware version 2.3 or later) (Audiobook and Podcast are not available) Fourth generation iPod® (Firmware version 3.1.1 or later) Fifth generation iPod® (Firmware version 1.1.2 or later) iPod® mini (Firmware version 1.41 or later) iPod® photo (Firmware version 1.2.1 or later) iPod® nano (Firmware version 1.2 or later) DISC/AUX button: When the DISC/AUX button is pushed with the system off and the iPod® connected, the system will turn on. If another audio source is playing and the iPod® is connected, push the DISC button repeatedly until the center display changes to the iPod® mode. Interface: The interface for iPod® operation shown on the vehicle center display is similar to the iPod® interface. Use the INFINITI controller and the ENTER or BACK button to play the iPod® with your favorite settings. The following items can be chosen from the menu list screen. For further information about each item, see the iPod® Owner's Manual...Playlists Artists Albums Songs Podcasts Genres Composers ... Make sure that your iPod® firmware is updated. Audio main operation Push the ignition switch to the ACC or ON position. Then, push the DISC/AUX button repeatedly to switch to the iPod® mode. If the system has been turned off while the iPod® was playing, pushing the ON·OFF/ VOL control knob will start the iPod®. Monitor, climate, audio, phone and voice recognition systems 4-59