2009 Infiniti FX50 Owner's Manual - Page 316
2009 Infiniti FX50 Manual
Page 316 highlights
DRIVING THE VEHICLE 5. To stop the engine, shift the selector lever to the P (Park) position and push the ignition switch to the OFF position. AUTOMATIC TRANSMISSION 7 speed automatic transmission The automatic transmission in your vehicle is electronically controlled by a transmission control module to produce maximum efficiency and smooth operation. Shown on the following pages are the recommended operating procedures for this transmission. Follow these procedures for maximum vehicle performance and driving enjoyment. is pushed to the LOCK, OFF or ACC position. 1. Keep the foot brake pedal depressed and push the selector lever button to shift into a driving gear. 2. Release the parking brake and foot brake, then gradually start the vehicle in motion. WARNING . Do not depress the accelerator pedal while shifting from P (Park) or N (Neutral) to R (Reverse), D (Drive), DS (Drive Sport) or manual shift mode. Always depress the brake pedal until shifting is completed. Failure to do so could cause you to lose control and have an accident. Cold engine idle speed is high, so use caution when shifting into a forward or reverse gear before the engine has warmed up. Never shift to P (Park) or R (Reverse) while vehicle is moving forward. Never shift to P (Park), D (Drive) or DS (Drive Sport) while vehicle is moving rearward. Failure to do so could cause you to lose control and have an accident. Starting and driving Starting the vehicle After starting the engine, fully depress the foot brake pedal and push the selector lever button before shifting the selector lever to the R (Reverse), N (Neutral), D (Drive), DS (Drive Sport) or Manual shift mode position. Be sure the vehicle is fully stopped before attempting to shift the selector lever. This automatic transmission model is designed so that the foot brake pedal must be depressed before shifting from P (Park) to any drive position while the ignition switch position is ON. The selector lever cannot be moved out of the P (Park) position and into any of the other gear positions if the ignition switch . . 5-13