2005 Jeep Liberty Owner's Manual - Page 225

STARTING AND OPERATING 225 Diesel Fuel-Water Separator A diesel fuel-water separator separates the water normally found in diesel fuel. A manual hand prime pump is located on the filter head for re-priming the fuel system. The fuel-water separator is located on the driver side cowl in the engine compartment. Refer to "2.8L Turbo Diesel Engine Compartment" in Section 7 for location. NOTE: If the "Water-In-Fuel Warning Light" (located in the instrument cluster) comes on, this indicates that water has collected in the fuel filter and should be drained immediately. See your authorized dealer for service. Should your vehicle run out of fuel, the fuel system must be re-primed in order to start the engine. Factors such as temperature, which affects the viscosity of the fuel, how long the vehicle has been sitting and other factors will influence how quickly the engine starts. Re-Priming the Diesel Fuel System The following procedure must be followed after completely running out of fuel. 1. Add a minimum of 2 gallons (7.57L) of diesel fuel to the fuel tank. 2. Open the hood. 5