2011 Jeep Grand Cherokee User Guide - Page 58

2011 Jeep Grand Cherokee Manual

Page 58 highlights

OFF-ROAD CAPABILITIES QUADRA-TRAC I® FOUR-WHEEL DRIVE Quadra-Trac I® Operating Instructions/Precautions - 3.6L Only • The Quadra-Trac I® is a single-speed (HI range only) transfer case, which provides convenient full-time four-wheel drive. No driver interaction is required. The Brake Traction Control (BTC) System, which combines standard ABS and Traction Control, provides resistance to any wheel that is slipping to allow additional torque transfer to wheels with traction. The Quadra-Trac II®/Quadra-Drive II® transfer case provides three mode positions: • 4WD HI • NEUTRAL • 4WD LOW • This transfer case is fully automatic in the 4WD HI mode. • When additional traction is required, the 4WD LOW position can be used to lock the front and rear driveshafts together and force the front and rear wheels to rotate at the same speed. The 4WD LOW position is intended for loose, slippery surfaces only. Driving in the 4WD LOW position on dry, hard-surfaced roads may cause increased tire wear and damage to driveline components. • When operating your vehicle in 4WD LOW, the engine speed is approximately three times that of the 4WD HI position at a given road speed. Take care not to overspeed the engine and do not exceed 25 mph (40 km/h). NOTE: • If shift conditions/interlocks are not met, or a transfer case motor temperature protection condition exists, a "For 4x4 Low Slow Below 5 MPH or 8 KPH Put Trans in N Press 4 Low" message will flash from the Electronic Vehicle Information Center (EVIC). QUADRA-TRAC II®/ QUADRA-DRIVE II® FOUR-WHEEL DRIVE Quadra-Trac II®/Quadra-Drive II® Operating Instructions/ Precautions Shifting Procedures 4WD HI To 4WD LOW • With the vehicle at speeds of 0 to 3 mph (0 to 5 km/h), the ignition switch in the ON/RUN position or the engine running, shift the transmission into NEUTRAL, and press the "4WD LOW" button once on the transfer case switch. The "4WD LOW" indicator light in the instrument cluster will begin to flash and remain on solid when the shift is complete. • The Quadra-Trac II®/Quadra-Drive II® transfer case is fully automatic in the normal driving 4WD HI mode. 56

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100

QUADRA-TRACI
®
FOUR-WHEELDRIVE
Quadra-Trac I
®
Operating
Instructions/Precautions - 3.6L
Only
• TheQuadra-TracI
®
isasingle-speed
(HIrangeonly)transfercase,which
providesconvenientfull-time
four-wheeldrive.Nodriverinteraction
isrequired.TheBrakeTractionControl
(BTC)System,whichcombines
standardABSandTractionControl,
providesresistancetoanywheelthat
isslippingtoallowadditionaltorque
transfertowheelswithtraction.
QUADRA-TRACII
®
/
QUADRA-DRIVEII
®
FOUR-WHEELDRIVE
Quadra-Trac II
®
/Quadra-Drive
II
®
Operating Instructions/
Precautions
• TheQuadra-TracII
®
/Quadra-Drive
II
®
transfercaseisfullyautomaticin
the normal driving 4WD HI mode.
TheQuadra-TracII
®
/Quadra-Drive
II
®
transfercaseprovidesthreemode
positions:
• 4WDHI
• NEUTRAL
• 4WDLOW
• Thistransfercaseisfullyautomaticin
the4WDHImode.
• Whenadditionaltractionisrequired,
the4WDLOWpositioncanbeused
tolockthefrontandreardriveshafts
togetherandforcethefrontandrear
wheelstorotateatthesamespeed.
The4WDLOWpositionisintended
forloose,slipperysurfacesonly.
Drivinginthe4WDLOWpositionon
dry,hard-surfacedroadsmaycause
increasedtirewearanddamageto
drivelinecomponents.
• Whenoperatingyourvehiclein4WD
LOW,theenginespeedis
approximatelythreetimesthatofthe
4WDHIpositionatagivenroad
speed.Takecarenottooverspeedthe
engineanddonotexceed25mph
(40km/h).
NOTE:
• Ifshiftconditions/interlocksarenotmet,
oratransfercasemotortemperature
protectionconditionexists,a“For4x4
LowSlowBelow5MPHor8KPHPut
TransinNPress4Low”messagewill
flashfromtheElectronicVehicle
InformationCenter(EVIC).
Shifting Procedures
4WD HI To 4WD LOW
• Withthevehicleatspeedsof0to
3mph(0to5km/h),theignition
switchintheON/RUNpositionorthe
enginerunning,shiftthetransmission
intoNEUTRAL,andpressthe“4WD
LOW”buttononceonthetransfer
caseswitch.The“4WDLOW”
indicatorlightintheinstrumentcluster
willbegintoflashandremainonsolid
whentheshiftiscomplete.
OFF-ROADCAPABILITIES
56