2011 Jeep Liberty Owner Manual - Page 420

418 STARTING AND OPERATING 14. Attach the vehicle to the tow vehicle using a suitable tow bar. 15. Release the parking brake. 16. Disconnect the negative battery cable, and secure it away from the negative battery post. NOTE: • Steps 1 through 5 are requirements that must be met prior to pressing the NEUTRAL (N) button, and must continue to be met until the four seconds elapse and the shift has been completed. If any of these requirements are not met prior to pressing the NEUTRAL (N) button or are no longer met during the four second timer, then the NEUTRAL (N) indicator light will flash continuously until all requirements are met or until the NEUTRAL (N) button is released. lights to be operable. If the ignition switch is not in the ON/RUN position, the shift will not take place and no position indicator lights will be on or flashing. • A flashing NEUTRAL (N) position indicator light indicates that shift requirements have not been met. Shifting Out Of NEUTRAL (N) Use the following procedure to prepare your vehicle for normal usage. 1. Bring the vehicle to a complete stop, leaving it connected to the tow vehicle. 2. Firmly apply the parking brake. 3. Reconnect the negative battery cable. 4. Turn the ignition switch to the LOCK/OFF position (if it has been moved or the engine has been started). • The ignition switch must be in the ON/RUN position 5. Turn the ignition switch to the ON/RUN position, but for a shift to take place and for the position indicator do not start the engine.