2011 Jeep Patriot Owner Manual - Page 207

UNDERSTANDING YOUR INSTRUMENT PANEL 205 turn the ignition switch to the ON/RUN position. To turn 25. Malfunction Indicator Light (MIL) off the message temporarily, press and release the Trip The Malfunction Indicator Light (MIL) is part of Odometer button on the instrument cluster. To reset the an Onboard Diagnostic system called OBD II that oil change indicator system (after performing the schedmonitors emissions, engine, and automatic transuled maintenance), refer to the following procedure: mission control systems. The light will illuminate when the key is in the ON/RUN position before engine start. If 1. Turn the ignition switch to the ON/RUN position. the light does not come on when turning the key from Do not start the engine. OFF to ON/RUN, have the condition checked promptly. 2. Fully depress the accelerator pedal slowly three Certain conditions, such as a loose or missing gas cap, times within 10 seconds. poor fuel quality, etc., may illuminate the light after 3. Turn the ignition switch to the OFF/LOCK position. engine start. The vehicle should be serviced if the light stays on through several of your typical driving cycles. In NOTE: If the indicator message illuminates when you most situations, the vehicle will drive normally and will start the vehicle, the oil change indicator system did not not require towing. reset. If necessary, repeat this procedure. 24. OFF ROAD Indicator - If Equipped The symbol illuminates (is armed) when the 4WD lock switch is activated and the shift lever is in LOW or REVERSE position. 4