2015 Jeep Patriot Owner Manual - Page 191

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 189 Reprogramming A Single HomeLink® Button (Canadian/Gate Operator) To reprogram a channel that has been previously trained, follow these steps: Security 1. Cycle the ignition to the ON/RUN position. system, entry door lock, home/office lighting, etc.,). The hand-held transmitter of the device may also be used at any time. 2. Push and hold the desired HomeLink® button until the indicator light begins to flash after 20 seconds. To do this, push and hold the two outside buttons for 20 seconds until the red indicator flashes. Note that all Do not release the button. channels will be erased. Individual channels cannot be 3. Without releasing the button proceed with "Canadian/ erased. Gate Operator Programming" step 2 and follow all The HomeLink® Universal Transceiver is disabled when remaining steps. the Vehicle Security Alarm is active. Using HomeLink® To operate, push and release the programmed HomeLink® button. Activation will now occur for the programmed device (i.e., garage door opener, gate operator, security It is advised to erase all channels before you sell or turn in your vehicle. 3