2015 Jeep Patriot Owner Manual - Page 458

456 WHAT TO DO IN EMERGENCIES NOTE: Sealant may leak out through the puncture in the NOTE: If the Mode Select Knob (5) is on Air Mode and tire. the pump is operating, air will dispense from the Air If the sealant (white fluid) does not flow within 0 - 10 Pump Hose (7) only, not the Sealant Hose (6). seconds through the Sealant Hose (6): If the sealant (white fluid) does flow through the 1. Press the Power Button (4) to turn Off the Tire Service Sealant Hose (6): Kit. Disconnect the Sealant Hose (6) from the valve 1. Continue to operate the pump until sealant is no longer stem. Make sure the valve stem is free of debris. flowing through hose (typically takes 30 - 70 seconds). As the sealant flows through the Sealant Hose (6), the Reconnect the Sealant Hose (6) to the valve stem. Pressure Gauge (3) can read as high as 70 psi (4.8 Bar). Check that the Mode Select Knob (5) is in the Sealant The Pressure Gauge (3) will decrease quickly from apMode position and not Air Mode. Press the Power proximately 70 psi (4.8 Bar) to the actual tire pressure Button (4) to turn On the Tire Service Kit. when the Sealant Bottle (1) is empty. 2. Connect the Power Plug (8) to a different 12 Volt power outlet in your vehicle or another vehicle, if 2. The pump will start to inject air into the tire immediately after the Sealant Bottle (1) is empty. Continue to available. Make sure the engine is running before operate the pump and inflate the tire to the pressure turning ON the Tire Service Kit. indicated on the tire pressure label on the driver-side 3. The Sealant Bottle (1) may be empty due to previous latch pillar (recommended pressure). Check the tire use. Call for assistance. pressure by looking at the Pressure Gauge (3).