1998 Lexus LX 470 Owners Manual - Page 97

INTERIOR EQUIPMENT GARAGE DOOR OPENER The garage door opener is manufactured under license from HomeLinkR and can be programmed to operate garage doors, estate gates, security lighting, etc. (a) Programming the garage door opener 14X041 " 1 Buttons 2 Indicator light The garage door opener has 3 buttons and can be programmed to operate 3 separate devices. 1. Decide which one of the 3 buttons you want to program. Push and hold down the button until the indicator light begins to flash. While holding this button, follow steps "2" and "3". 2. Bring the hand held garage door opener within about 25mm (1 in.) of the button being programmed and push the button on the hand held garage door opener. The signal from the hand held garage door opener is sent to the vehicle's opener. 3. When the frequency and code is registered, the indicator light flashes rapidly. At this point, you can release both buttons. 4. To program the remaining buttons, repeat steps "1" through "3". If you want to write a new program over the program set already, select a button you want to program and repeat the procedure from step "1". The previous program is erased and a new program will be set. If the transmitter has a "rolling code" feature, it is necessary to program the in-garage receiver, after programming the garage door opener in the vehicle. For setting the in-garage receiver, refer to the instruction manual for the receiver. After setting the in-garage receiver, push the programmed button on the vehicle for about 1 to 2 seconds within the operational range. Garage door openers manufactured before 1982 cannot be programmed. 79