2004 Lexus SC 430 User Guide - Page 67

INTERIOR EQUIPMENT 3. Press and release the vehicle's programmed HomeLinkR button twice. The garage door may open. If the door does open, the programming process is complete. If the door does not open, press and release the button a third time. This third press and release will complete the programming process by opening the garage door. The ceiling mounted garage door opener motor should now recognize the HomeLinkR unit and be able to activate the garage door up/down. 4. Repeat steps 1 through 3 for each remaining button to program another rolling code system. HomeLinkR Programming an entrance gate / Programming all devices in the Canadian market 1. Decide which of the 3 HomeLinkR buttons you want to program. 2. Place your hand-held gate/device transmitter 25 to 75 mm (1 to 3 in.) away from the surface of the HomeLinkR. Keep the indicator light on the HomeLink R in view while programming. 3. Press and hold the selected HomeLinkR button. 4. Continuously press and release (cycle) the hand- held gate/device transmitter button every two seconds until step 5 is complete. 5. When the indicator light on the HomeLinkR changes from a slow to a rapid flash after 20 seconds, you can release both buttons. 6. Test the operation of the HomeLinkR by pressing the newly programmed button. Check to see if the gate/device operates correctly. 7. Repeat steps 1 through 6 for each remaining HomeLinkR button to program another device. INFORMATION If you register a program in the HomeLinkR using a "Rolling Code" type transmitter, the transmitter must be reprogrammed to use it again. 73