2007 Lincoln Mark LT Owner Guide 2nd Printing - Page 117

Locks and Security 1. Turn the ignition to the 3 (ON) position, then press the control three times. 2. Turn the ignition to the 1 (OFF/LOCK) position, then press the control three times. 3. Turn the ignition to the 3 (ON) position; the horn will chirp to indicate the driver configuration mode has been activated. 4. Within five seconds, press the control two times. Note: One horn chirp should be heard, indicating the system has been disabled. Conversely, a horn chirp followed by a honk will indicate the system is enabled. Pressing the power door control two times again will turn the feature ON if it was previously OFF, or OFF if it was previously ON. Every two consecutive presses of the control after successfully entering the configuration mode will change the enable/disable condition of the feature. 5. Turn the ignition to the 1 (OFF/LOCK) position to exit programming. Note: After exiting the driver configuration mode, the horn will chirp once to indicate a feature has been activated/deactivated. KEYLESS ENTRY SYSTEM You can use the keyless entry keypad to: • lock all vehicle doors. • unlock only the driver's door. • unlock all vehicle doors. • program/erase the customer keycode. • enable/disable the autolocking feature. The keypad can be operated with the factory set 5-digit entry code; this code is located on the owner's wallet card in the glove box, is marked on the computer module, and is available from your authorized dealer. You can also create your own 5-digit personal entry code. When pressing the controls on the keypad, press the middle of the controls to ensure a good activation. Programming a personal entry code To create your own personal entry code: 1. Enter the factory set code (keypad will illuminate when pressed). 2. Within five seconds press the 1 • 2 on the keypad. 117 2007 Mark LT (mlt) Owners Guide (post-2002-fmt) USA (fus)