2007 Lincoln Mark LT Owner Guide 2nd Printing - Page 98

Driver Controls Compass zone/calibration adjustment 1. Determine your magnetic zone by referring to the zone map. 3 2 2. Turn ignition to the ON position. 3. Start the engine. 4 4. From Info menu, select the Compass/Odometer function. (Do 5 not select Trip, DTE, or AFE. The top of the message center must be blank). 5. Press and hold the SETUP and RESET controls until the message center display changes to show the current zone setting (XX). 6. Press the RESET, then press SETUP control repeatedly until the correct zone setting for your geographic location is displayed on the message center. The range of zone values are from 01 to 15 and "wraps" back to 01. 7. To exit the zone setting mode, and to "lock in" your change, press and release the RESET control. 1 15 14 13 12 6 7 8 9 1011 Perform compass calibration in an open area free from steel structures and high voltage lines. For optimum calibration, turn off all electrical accessories (heater/air conditioning, wipers, etc.) and make sure all vehicle doors are shut. 8. Press the RESET control to start the compass calibration function. 9. Slowly drive the vehicle in a circle (less than 3 mph [5 km/h]) until the CIRCLE SLOWLY TO CALIBRATE display changes to CALIBRATION COMPLETED. It will take up to five circles to complete calibration. 98 2007 Mark LT (mlt) Owners Guide (post-2002-fmt) USA (fus)