2010 Lincoln Town Car Owner Guide 1st Printing - Page 93

Locks and Security 1. Insert a previously programmed 3 coded key into the ignition. 2. Turn the ignition from the 1 (off) 2 position to the 3 (on) position. Keep 4 the ignition in the 3 (on) position for at least one second, but no more than 10 seconds. 3. Turn the ignition to the 1 (off) 1 position, and remove the coded key from the ignition. 4. After three seconds but within ten seconds of removing the previously programmed coded key, insert the other previously programmed coded key into the ignition. 5. Turn the ignition from the 1 (off) position to the 3 (on) position. Keep the ignition in the 3 (on) position for at least one second but not more than 10 seconds. 6. Turn the ignition to the 1 (off) position, and remove the second key from the ignition. 7. Within twenty seconds of removing the previously programmed coded key, insert the unprogrammed key (new/valet key) into the ignition. 8. Turn the ignition from the 1 (off) position to the 3 (on) position. Keep the ignition in the 3 (on) position for at least one second. 9. Your new unprogrammed key is now programmed. If the key has been successfully programmed it will start the vehicle's engine and the theft indicator light will illuminate for three seconds and then go out. If the key was not successfully programmed, it will not start your vehicle's engine and the theft indicator light will flash on and off rapidly. If failure repeats, bring your vehicle to your authorized dealer to have the new key(s) programmed. To program additional new unprogrammed key(s), repeat this procedure from Step 1 for each additional key. PERIMETER ALARM SYSTEM (IF EQUIPPED) The perimeter anti-theft system will warn you in the event of an unauthorized entry to your vehicle. If there is any potential perimeter anti-theft problem with your vehicle, ensure ALL remote entry transmitters are taken to the authorized dealer to aid in troubleshooting. 93 2010 Town Car (tow) Owners Guide, 1st Printing USA (fus)