2011 Lincoln Navigator Owner Guide 1st Printing - Page 111
2011 Lincoln Navigator Manual
Page 111 highlights
Locks and Security 2. Within three seconds press the . 3. A tone will be heard when the deactivation is complete. 4. Repeat this procedure for transmitter if desired. Replacing the battery The integrated keyhead transmitter (IKT) or intelligent access key (IA key) uses one coin type three-volt lithium battery CR2032 or equivalent. Integrated keyhead transmitter (IKT) To replace the battery: 1. Twist a thin coin in the slot near 1 the key ring to remove the battery cover (1). 2 Note: Do not wipe off any grease on the battery terminals on the back surface of the circuit board. 3 2. Carefully peel up the rubber gasket (2) from the transmitter if it does not come off with battery cover. 3. Remove the old battery (3). Note: Please refer to local regulations when disposing of transmitter batteries. 4. Insert the new battery. Refer to the instructions inside the IKT for the correct orientation of the battery. Press the battery down to ensure that the battery is fully seated in the battery housing cavity. 5. Snap the battery cover back onto the key. Note: Replacement of the battery will not cause the IKT or IA key to become de-programmed from your vehicle. They should operate normally after battery replacement. Replacing lost integrated keyhead transmitters (IKTs) If you would like to have your integrated keyhead transmitters reprogrammed because you lost one, or would like to buy additional IKTs, you can either reprogram them yourself, or take all IKTs to your authorized dealer for reprogramming. How to reprogram your integrated keyhead transmitters (IKTs) To program a new integrated keyhead transmitter yourself, refer to Programming spare keys in the SecuriLock passive anti-theft system section of this chapter. Note: At least two IKTs are required to perform this procedure yourself. 111 2011 Navigator (nav) Owners Guide, 1st Printing USA (fus)