2011 Lincoln Town Car Owner Guide 2nd Printing - Page 50
2011 Lincoln Town Car Manual
Page 50 highlights
Lights High beam • Disconnect the electrical connector from the bulb. • Remove the bulb by turning it counterclockwise, then pull it straight out. WARNING: Handle a halogen headlamp bulb carefully and keep out of children's reach. Grasp the bulb only by its plastic base and do not touch the glass. The oil from your hand could cause the bulb to break the next time the headlamps are operated. 6. To complete installation, follow the removal procedure in reverse order. Note: To ensure a good seal, attach the bulb cover and partially tighten the screws. Check to ensure the gasket is fully centered. Finish tightening the screws in a criss-cross pattern (upper-left, lower right etc.) Replacing HID low beam headlamp bulbs (if equipped) The low beam headlamps on your vehicle use a "high intensity discharge" source. These lamps operate at a high voltage. When the bulb is burned out, the bulb and starter capsule assembly must be replaced by your authorized dealer. Replacing front parking lamp/turn signal/sidemarker/cornering bulbs The front parking lamp/turn signal/sidemarker/cornering bulbs are located in the headlamp assembly. To replace any of the bulbs, follow this procedure: 1. Make sure the headlamp switch is in the off position, then open the hood. 2. Remove the retainers and the radiator cover. 3. Remove the bolts, then pull the headlamp assembly forward and disconnect the electrical connector. 50 2011 Town Car (tow) Owners Guide, 2nd Printing USA (fus)