2011 Lincoln Town Car Owner Guide 2nd Printing - Page 67
2011 Lincoln Town Car Manual
Page 67 highlights
Driver Controls The indicator light above the selected button will turn on to confirm that the Car2U system is responding to the button command. To program another rolling code device such as an additional garage door opener, a security device or home lighting, repeat Steps 1 through 4 substituting a different function button in Step 3 than what you used for the garage door opener. For example, you could assign the left-most button to the garage door, the center button to a security device, and the right-most button to another garage door opener. Note: The Car2U system allows for three devices to be programmed. If you need to change or replace any of the three devices after it has been initially programmed, it is necessary to erase the current settings using the Erasing the Car2U Home Automation System buttons procedure and then programming all of the devices being used. Fixed code programming Note: Do not program the Car2U system with the vehicle in the garage. Make sure that your key is on and engine off while programming the transmitter. 1. To program units with fixed code DIP switches, you will need the garage door hand-held transmitter, paper and a pen or pencil. 2. Open the battery cover and record the switch settings from left to right for all 8 to 12 switches. Use the figure below: When a switch is in the up, on, or + position, circle "L." When a switch is in the middle, neutral, or 0 position, circle "M." When a switch is in the down, off, or - position, circle "R." 67 2011 Town Car (tow) Owners Guide, 2nd Printing USA (fus)