2011 Lincoln Town Car Owner Guide 2nd Printing - Page 69
2011 Lincoln Town Car Manual
Page 69 highlights
Driver Controls After successful programming, you will be able to operate your Car2U system by pressing the button you programmed to activate the opener. The indicator light above the selected button will turn on to confirm that the Car2U system is responding to the button command. Erasing the Car2Uா Home Automation System buttons Note: The system allows for three devices to be programmed. If you need to change or replace any of the three devices after it has been initially programmed, it will be necessary to erase the current settings using the procedure below and then reprogramming all of the devices being used. To erase programming on the Car2U system (individual buttons cannot be erased), use the following procedure: 1. Firmly press the two outside Car2U system buttons simultaneously for approximately 20 seconds until the indicator lights begin to blink rapidly. The indicator lights are located directly above the buttons. 2. Once the indicator lights begin to blink, release your fingers from the buttons. The codes for all buttons are erased. If you sell your vehicle equipped with the Car2U system, it is recommended that you erase the programming for security reasons. FCC and RSS-210 Industry Canada Compliance The Car2U system complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received including interference that may cause undesired operation. Changes and modifications to the Car2U system transmitter by other than an authorized service facility could void authorization to use the equipment. 69 2011 Town Car (tow) Owners Guide, 2nd Printing USA (fus)