2015 Lincoln MKZ Owner Manual Printing 1 - Page 153

Universal Garage Door Opener 2. The indicator light will begin to flash after 20 seconds. Without releasing the button, follow Step 1 in the Programming section. For questions or comments, contact HomeLink at www.homelink.com or 1-800-355-3515. Programming to a Genie Intellicode 2 Garage Door Opener Note: The Genie Intellicode 2 transmitter must already be programmed to operate with the garage door opener. Note: To program HomeLink to the transmitter you must first put the transmitter into programming mode. E142658 3. Press and hold the function button you want to program for 2 seconds, then release. Repeat this step. Depending on your brand of garage door opener, you may need to repeat this sequence a third time. Erasing the Function Button Codes Note: You cannot erase individual buttons. E142660 1. Press and hold the outer two function buttons simultaneously for approximately 20 seconds until the indicator lights above the buttons flash rapidly. 2. When the indicator lights flash, release the buttons. The codes for all buttons are erased. Reprogramming a Single Button To program a device to a previously trained button, follow these steps: 1. Press and hold the desired button. Do NOT release the button. 150 MKZ (), enUSA