2015 Lincoln MKZ Owner Manual Printing 1 - Page 300
2015 Lincoln MKZ Manual
Page 300 highlights
Maintenance 4. On the wall or screen you will observe a flat zone of high intensity light located at the top of the right hand portion of the beam pattern. If the top edge of the high intensity light zone is not at the horizontal reference line, the headlamp will need to be adjusted. Horizontal Aim Adjustment Horizontal aim is not required for this vehicle and is not adjustable. CHANGING A BULB Lamp Assembly Condensation Exterior lamps are vented to accommodate normal changes in pressure. Condensation can be a natural by-product of this design. When moist air enters the lamp assembly through the vents, there is a possibility that condensation can occur when the temperature is cold. When normal condensation occurs, a thin film of mist can form on the interior of the lens. The thin mist eventually clears and exits through the vents during normal operation. Clearing time may take as long as 48 hours under dry weather conditions. Examples of acceptable condensation are: • Presence of thin mist (no streaks, drip marks or droplets). • Fine mist covers less than 50% of the lens. 297 Examples of unacceptable moisture (usually caused by a lamp water leak) are: • Water puddle inside the lamp. • Large water droplets, drip marks or streaks present on the interior of the lens. Take your vehicle to a dealer for service if any of the above conditions of unacceptable moisture are present. Replacing Bulbs For replacing bulbs, see your authorized dealer. BULB SPECIFICATION CHART Replacement bulbs are specified in the chart below. Headlamp bulbs must be marked with an authorized "D.O.T." for North America to make sure they have the proper lamp performance, light brightness, light pattern, and safe visibility. The correct bulbs will not damage the lamp assembly or void the lamp assembly warranty and will provide quality bulb illumination time. E150095 5. Locate the vertical adjuster on each headlamp. Using a Phillips #2 screwdriver, turn the adjuster either clockwise or counterclockwise in order to adjust the vertical aim of the headlamp. The horizontal edge of the brighter light should touch the horizontal reference line. 6. Close the hood and turn off the lamps. MKZ (), enUSA