2004 Mazda MAZDA6 Owner's Manual - Page 143
2004 Mazda MAZDA6 Manual
Page 143 highlights
J56J_8S11-EA-03G_Edition1.book Page 47 Tuesday, June 24, 2003 6:29 PM Driving Your Mazda Switches and Controls M Programming the HomeLink System NOTE FCC ID: NZLSTDHL3 CANADA:4112104541A This device complies with FCC rules part 15. Operation is subject to the following conditions: 1- This device may not cause any harmful interference and 2- This device must accept any interference that may be received including interference that may cause undesired operation. NOTE CAUTION When programming a garage door opener or a gate, disconnect the power to these devices before performing programming, as continuous operation of the devices could damage the motor. The HomeLink system provides 3 buttons which can be individually selected and programmed using the transmitters for current, on-market devices as follows: 1. Press and hold the two outer HomeLink buttons (buttons one and three) - releasing only when the indicator light begins to flash (after 20 seconds). Do not hold the buttons for longer than 30 seconds and do not repeat step 1 to program a second and/ or third hand-held transmitter to the remaining two HomeLink buttons. 2. Position the end of your hand-held transmitter 2.5-7.5 cm (1-3 inches) away from the HomeLink button you wish to program while keeping the indicator light in view. 3. Simultaneously press and hold both the chosen HomeLink and hand-held transmitter buttons. Do not release the buttons until step 4 has been completed. NOTE The programming will not be erased even if the battery is disconnected. M Pre-programming the HomeLink System NOTE It is recommended that a new battery be placed in the hand-held transmitter of the device being programmed to HomeLink for quicker training and accurate transmission of the radiofrequency signal. • Verify that there is a remote control transmitter available for the device you would like to program. • Disconnect the power to the device. Some gate operators and garage door openers may require you to replace this Programming Step 3 with procedures noted in the "Gate Operator/Canadian Programming" section. 5-47 Form No. 8S11-EA-03G