2006 Mercedes R-Class Owner's Manual - Page 497
2006 Mercedes R-Class Manual
Page 497 highlights
Practical hints Jump starting If the battery is discharged, the engine can be started with jumper cables and the battery of another vehicle. Observe the following: Jump starting should only be performed using the jump-start contacts in the engine compartment ( page 497). Jump starting should only be performed when the engine and catalytic converter are cold. Do not start the engine if the battery is frozen. Let the battery thaw out first. Only jump start from batteries with the same voltage rating (12V). Jump starting with a more powerful battery could damage the vehicle's electrical system, which will not be covered by the Mercedes-Benz Limited Warranty. Use only jumper cables with sufficient cross-section and insulated terminal clamps. Always make sure the jumper cables are not on or near pulleys, fans or other parts that move when the engine is started or running. Warning! G Failure to follow these directions will cause damage to the electronic components, and can lead to a battery explosion and severe injury or death. Never lean over batteries while connecting or jump starting, you might get injured. Battery fluid contains sulfuric acid. Do not allow this fluid to come in contact with eyes, skin or clothing. In case it does, immediately flush affected area with water, and seek medical help if necessary. A battery will also produce hydrogen gas, which is flammable and very explosive. Keep flames or sparks away from battery, avoid improper connection of jumper cables, smoking, etc. Attempting to jump start a frozen battery can result in it exploding, causing personal injury. Read all instructions before proceeding. ! Avoid repeated and lengthy starting attempts. Do not attempt to start the engine using a battery quick charge unit. If the engine does not run after several unsuccessful starting attempts, have it checked at the nearest authorized Mercedes-Benz Light Truck Center. Excessive unburned fuel generated by repeated failed starting attempts may damage the catalytic converter. Make sure the jumper cables do not have loose or missing insulation. Make sure the cable clamps do not touch any other metal part while the other end is still attached to a battery. 496