2007 Mercedes GL-Class Owner's Manual - Page 526
2007 Mercedes GL-Class Manual
Page 526 highlights
Practical hints Flat tire Position jack 3 under the take-up bracket 2 so that it is always vertical (plumb-line) as seen from the side, even if the vehicle is parked on an incline. 1 Wheel wrench On wheel to be changed, loosen but do not yet remove the wheel bolts (approximately one full turn with wheel wrench 1). The jack take-up brackets are located directly behind the front wheel housings and in front of the rear wheel housings. 2 Take-up bracket 3 Jack 4 Crank ! Do not position the jack on the body of the vehicle, as this may cause damage to the vehicle. ! Vehicles with factory-mounted running-boards*: Your vehicle is equipped with a scissors-type jack (located under the cargo compartment floor) designed for use with factory-mounted running boards. Only use this jack when jacking up vehicles with factory-mounted running boards as otherwise the vehicle's underbody can be damaged. See separate instructions for scissors-type jack. Place jack 3 on firm ground. Turn crank 4 clockwise until jack 3 is fully seated in take-up bracket 2 and the jack base evenly meets the ground. Continue to turn crank 4 until the wheel is a maximum of 1.2 in (3 cm) from the ground. 525
![](/manual_guide/autos/2007-mercedes-glclass-owners-manual-f9c949f/526.png)