2008 Mercedes CLS-Class Owner's Manual - Page 87

Safety and Security Occupant safety Child seat anchors - LATCH type This vehicle is equipped with two LATCH (Lower Anchors and Tethers for CHildren) type anchors (at each of the rear seats) for the installation of a "LATCH" child seat with the matching mounting fittings. The anchors are located behind an upholstery blend. 2 Hook 3 Anchorage ring Securely fasten hook 2 to anchorage ring 3. Lift upholstery blend up to access the anchors. Install child seat according to the manufacturer's instructions. i Non-LATCH type child seats may also be used and can be installed using the vehicle's seat belt system. Install child seat according to the manufacturer's instructions. Warning! G i For safety, make sure hook 2 has attached to ring 3 beyond the safety catch, as illustrated. Once the top tether anchorage hook is attached, the child restraint itself can be secured. Tighten the top tether strap according to the child restraint manufacturer's instructions. 1 Indicates the position of the anchors 2 Anchors Children too big for a toddler restraint must ride in seats using regular seat belts. Position shoulder belt across chest and shoulder, not face or neck. A booster seat may be necessary to achieve proper seat belt positioning for children over 41 lbs until they reach a height where a lap/shoulder belt fits properly without a booster. Install child seat according to manufacturer's instructions. The child seat must be firmly attached to the right and left side anchors 2. 86