2010 Mercedes GLK-Class Owner's Manual - Page 208
2010 Mercedes GLK-Class Manual
Page 208 highlights
206 Useful features X Step 4: Using both hands, simultaneously press hand-held remote control button B and the desired signal transmitter button (;, = or ?). Do not release the buttons until step 5 is completed. Indicator lamp : will flash, first slowly and then rapidly. Controls in detail Interior rear view mirror with integrated remote control Hand-held remote control A is not part of the vehicle equipment. i Indicator lamp : flashes immediately the first time the signal transmitter button is programmed. If this button has already been programmed, the indicator lamp will start flashing after 20 seconds. X Programming the integrated remote control X X Step 1: Switch on the ignition. Step 2: If you have previously programmed a signal transmitter button and wish to retain its programming, proceed to step 3. or X If you are programming the integrated remote control for the first time, press and hold the two outer signal transmitter buttons ; and ? and release them when indicator lamp : begins to flash after approximately 20 seconds. Do not hold the buttons for longer than 30 seconds. This procedure erases any previous settings for all three channels and initializes the memory. If you later wish to program a second and/or third hand-held transmitter to the remaining two signal transmitter buttons, do not repeat this step and begin directly with step 3. X Step 3: Hold the end of hand-held remote control A of the device you wish to train approximately 2 to 12 in (5 to 30 cm) away from the signal transmitter button (;, = or ?) to be programmed, while keeping indicator lamp : in view. Step 5: After indicator lamp : changes from a slow to a rapidly flashing light, release the hand-held remote control button and the signal transmitter button. X Step 6: Press and hold the just-trained signal transmitter button (;, = or ?) and observe indicator lamp :. If indicator lamp : stays on constantly, programming is complete and your device should activate when the respective signal transmitter button (;, = or ?) is pressed and released. i If indicator lamp : flashes rapidly for approximately 2 seconds and then turns to a constant light, continue with programming steps 8 through 12 as your garage door opener may be equipped with the "rolling code" feature. X Step 7: To program the remaining two signal transmitter buttons, repeat the steps above starting with step 3. Rolling code programming To train a garage door opener (or other rolling code devices) with the rolling code feature, follow these instructions after completing the "Programming" portion (steps 1 through 6) of this text. For your convenience and to complete the procedure faster, you might want to have someone assist you.