2006 Mercury Monterey Owner Guide 1st Printing - Page 245
2006 Mercury Monterey Manual
Page 245 highlights
Roadside Emergencies 11. Remove the jack and fully 1 tighten the lug nuts in the order shown. Refer to Wheel lug nut torque specifications later in this 3 4 chapter for the proper lug nut torque specification. 12. Installing the optional wheel cover or center ornament: 5 2 • If equipped with a bolted-on wheel cover, install the wheel cover and tighten the five plastic nuts until they click (do not use power tools on these nuts). • If equipped with the center ornament, install the center ornament by snapping it back into place. 13. Put flat tire, jack and lug wrench away in the proper stowage locations. Stowing the flat and full-size tire Failure to follow these instructions may result in personal injury. Do not install the flat tire or any full size tire underneath the vehicle. Remove tether kit from the jack storage area. 1. Place tire upright inside the vehicle near the rear of the vehicle with the valve stem facing the front of the vehicle. 2. Pass the cable retainer through the center of the wheel. 3. Raise the tire and secure both ends of the cable with the wing nut provided in the tether cable kit, by installing it on the luggage back panel and turning the wing screw clockwise. You will hear an audible click when the tire is properly secured. 4. Check that the flat tire is properly secured. Stowing the spare tire 1. Lay the spare, inflated tire on the ground with the valve stem facing down. 2. Insert the primary wheel retainer through the center of the wheel. 3. Use the winch mechanism to pull, and raise the tire under the vehicle. 4. Raise the tire by turning the lug nut wrench clockwise until the hex nut ratchets. 245 2006 Monterey (mty) Owners Guide (post-2002-fmt) USA (fus)