2007 Mercury Milan Owner's Manual - Page 233

Maintenance and Specifications engine must warm up to its normal operating temperature. Once started, do not turn off the engine until the above driving cycle is complete. POWER STEERING FLUID Refer to the scheduled maintenance information for the service interval schedules. If adding fluid is necessary, use only MERCON ATF. • 2.3L I4 Engine • 3.0L V6 Engine 1. Start the engine and let it run until it reaches normal operating temperature (the engine coolant temperature gauge indicator will be near the center of the normal area between H and C). 2. While the engine idles, turn the steering wheel left and right several times. 3. Turn the engine off. 4. Check the fluid level in the reservoir. It should be between the MIN/MAX or upper and lower lines. Do not add fluid if the level is in this range. 5. If the fluid is low, add fluid in small amounts, continuously checking the level until it reaches the range between the MIN/MAX or upper and lower lines. Be sure to put the cap back on the reservoir. 233 2006 Milan (mln) Owners Guide (post-2002-fmt) USA (fus)