2009 Mercury Sable Scheduled Maintenance Guide 1st Printing - Page 20

NORMAL SCHEDULE TRUCKS, FULLSIZE VANS & SUVS 52,500 miles ❑ Change engine oil and replace oil filter ❑ Rotate tires, inspect tires for wear and measure ❑ ❑ tread depth (vehicles with dual rear wheels should only rotate if unusual wear is noted) Inspect the wheels and related components for abnormal noise, wear, looseness, or drag Perform multi-point inspection (recommended) RO#: DATE: DEALER VALIDATION: P&A CODE: MILEAGE: 60,000 miles ❑ Change engine oil and replace oil filter ❑ Change automatic transmission fluid on all vehicles equipped with the TorqShift transmission. Consult your dealer for your particular requirements. Replace cabin air filter (if equipped) Replace climate-controlled seat filter (if equipped) Replace engine air filter Replace fuel filter (except Escape, Mariner, F-Series [non Super Duty], Expedition/Navigator [short wheel base only], E-Series) Replace wheel bearing grease and grease seals on 4x2 front wheel bearings (if non-sealed bearings) Inspect steering linkage, ball joints, suspension, tie rod ends, driveshaft, and U-joints (lubricate if equipped with Zerk fittings) Inspect engine cooling system and hoses Inspect brake pads, shoes, rotors, drums, brake lines and hoses and parking brake system. Inspect half shaft boots (if equipped) Inspect exhaust system and heat shields Inspect and lubricate 4x4 front axle U-joints Rotate tires, inspect tires for wear and measure tread depth (vehicles with dual rear wheels should only rotate if unusual wear is noted) Inspect the wheels and related components for abnormal noise, wear, looseness, or drag Perform multi-point inspection (recommended) DEALER VALIDATION: RO#: DATE: P&A CODE: MILEAGE: 20 Scheduled Maintenance 2009 Scheduled Maintenance Guide (smg) Scheduled Maintenance Guide USA (fus)