2009 Mercury Sable Scheduled Maintenance Guide 1st Printing - Page 25

NORMAL SCHEDULE TRUCKS, FULLSIZE VANS & SUVS 120,000 miles ❑ Change engine oil and replace oil filter ❑ Replace cabin air filter (if equipped) ❑ Replace climate-controlled seat filters (if equipped) ❑ Replace engine air filter ❑ Replace fuel filter (except Escape, Mariner, F-Series [non Super Duty], Expedition/Navigator [short wheel base only], E-Series) Replace PCV valve on all light trucks over 6,000 lbs. Gross Vehicle Weight (GVW) (except 3V engines) Change automatic transmission fluid on all vehicles equipped with the TorqShift transmission. Consult your dealer for your particular requirements. Replace wheel bearing grease and grease seals on 4x2 front wheel bearings (if non-sealed bearings) Inspect steering linkage, ball joints, suspension, tie rod ends, driveshaft, and U-joints (lubricate if equipped with Zerk fittings) Inspect engine cooling system and hoses Inspect brake pads, shoes, rotors, drums, brake lines and hoses and parking brake system. Inspect half shaft boots (if equipped) Inspect exhaust system and heat shields Inspect accessory drive belts Inspect automatic transmission fluid level (if equipped with an underhood dipstick) Inspect and lubricate 4x4 front axle U-joints Rotate tires, inspect tires for wear and measure tread depth (vehicles with dual rear wheels should only rotate if unusual wear is noted) Inspect the wheels and related components for abnormal noise, wear, looseness, or drag Perform multi-point inspection (recommended) ❑ ❑ DEALER VALIDATION: Normal Schedule Trucks, Fullsize Vans & SUVs RO#: DATE: P&A CODE: MILEAGE: Scheduled Maintenance 25 2009 Scheduled Maintenance Guide (smg) Scheduled Maintenance Guide USA (fus)