1998 Nissan Sentra Owner's Manual - Page 37
1998 Nissan Sentra Manual
Page 37 highlights
To install the anchor bracket, a metric bolt of the dimensions listed below must be used. Bolt diameter: 8.0 mm Bolt length: more than 1.18 in (30 mm) Thread pitch: 1.25 mm Secure the top strap to the attaching bolt which provides the straightest installation of the top strap. WARNING Child restraint anchor points are designed to withstand only those loads imposed by correctly fitted child restraints. Under no circumstances are they to be used for adult seat belts or harnesses. There are pre-cut circles at each anchor point location that should break away from the shelf support material when pressure is applied to them. Remove the bolt after you feel the pre-cut circle separate from the shelf support material. 2. Cut a small slit through the parcel shelf fabric at the anchor point location. Reach through the fabric with a tool such as a pair of needle-nose pliers and remove the pre-cut circle in the parcel shelf support material. APD0635 Anchor point locations Anchor points are located under the rear parcel shelf finisher. To use attaching hardware for child restraints with top straps, follow these instructions carefully: 1. Open the trunk and find the anchor point nuts on the underside of the rear parcel shelf. Thread a bolt (8.0 mm diameter, 1.25 pitch) up through the nut behind the seating position where the child restraint will be installed and use it to break through the rear parcel shelf support material. 3. Install the bolt through the top strap hook and into the anchor point nut. 4. Be sure to follow all of the instructions that accompany the top strap attaching hardware. 1-30 Seats, restraints and supplemental air bag systems