2008 Nissan Quest Owner's Manual - Page 195

● To quickly remove ice or fog from the windows, turn the fan control dial to the highest setting and the temperature control to the full HOT position. ● When the position is selected, the air conditioner automatically turns on (however, A/C will not appear on the display) if the outside temperature is more than 36°F (2°C). The air conditioning system will continue to operate until the fan control dial is turned to OFF or the vehicle is shut off, even if an air flow control button other than is selected. This dehumidifies the air which helps defog the windshield. The mode automatically turns off, allowing outside air to be drawn into the passenger compartment to further improve the defogging performance. 4. Turn the temperature control dial to the desired position. Operating tips Clear snow and ice from the wiper blades and air inlet in front of the windshield. This improves heater operation. Heating and defogging This mode heats the interior and defogs the windshield. 1. Press the air flow control button. 2. Turn the fan control dial to the desired position. 3. Turn the temperature control dial to the desired position between the middle and the hot position. ● When the position is selected, the air conditioner automatically turns on (however, A/C will not appear on the display) if the outside temperature is more than 36°F (2°C). The air conditioning system will continue to operate until the fan control dial is turned to OFF or the vehicle is shut off, even if an air flow control button other than is selected. This dehumidifies the air which helps defog the windshield. The mode automatically turns off, allowing outside air to be drawn into the passenger compartment to further improve the defogging performance. AIR CONDITIONER OPERATION Start the engine, turn the fan control dial to the desired position, and push in the button to activate the air conditioner. When the air conditioner is on, cooling and dehumidifying functions are added to the heater operation. The air conditioner cooling function operates only when the engine is running. Cooling This mode is used to cool and dehumidify the air. 1. Push the 2. Press the button to the OFF position. air flow control button. Bi-level heating The bi-level mode directs warmed air to the side and center vents and to the front and rear floor outlets. 1. Push the button to the OFF position ( shown on display). 2. Press the air flow control button. 3. Turn the fan control dial to the desired position. 3. Turn the fan control dial to the desired position. 4. Push the the display. button. A/C will appear on 5. Turn the temperature control dial to the desired position. Display screen, heater, air conditioner, audio and phone systems 4-33