2010 Nissan Titan King Cab Owner's Manual - Page 169

9. GUIDE VOICE button* 10. 11. zoom out button* zoom in button* If you use the system with the engine not running (ignition ON or ACC) for a long time, it will use up all the battery power, and the engine will not start. Reference symbols: ENTER button - This is a button on the control panel. "Display" key - This is a select key on the screen. By selecting this key you can proceed to the next function. SETTING UP THE START-UP SCREEN When you place the ignition switch in the ACC or ON position, the system start-up warning is displayed on the screen. Read the warning and select the "OK" key by pressing the ENTER button. If you do not press the ENTER button, the Navigation system will not proceed to the next step in the Navigation display. If you do not touch a button or screen key for more than 1 minute on the system start-up warning screen, the screen will change to the audio screen automatically. To proceed to the next step, refer to the separate Navigation System Owner's Manual. *For Navigation system control buttons, refer to the separate Navigation System Owner's Manual. CAUTION ● The glass screen on the liquid crystal display may break if it is hit with a hard or sharp object. If the glass breaks, do not touch the liquid crystalline material, which contains a small amount of mercury. In case of contact with skin, wash immediately with soap and water. ● To clean the display, never use a rough cloth, alcohol, benzine, thinner or any kind of solvent or paper towel with a chemical cleaning agent. They will scratch or deteriorate the panel. ● Do not splash any liquid such as water or car fragrance on the display. Contact with liquid will cause the system to malfunction. When you use this system, make sure the engine is running. HOW TO USE THE JOYSTICK AND ENTER BUTTON Use the joystick to choose an item on the display screen. Move the joystick up, down, left or right to highlight an item. Then press the ENTER button to select the item or perform the action. HOW TO USE THE BACK BUTTON This button has two functions. ● Go back to the previous display (cancel). If you press the BACK button during setup, the setup will be canceled and/or the display will return to the previous screen. ● Finish setup. In some screens pressing the BACK button accepts the changes made during setup. Display screen, heater, air conditioner, audio and phone systems 4-3