2010 Nissan Titan King Cab Owner's Manual - Page 257

IGNITION SWITCH ● If at all possible, avoid sharp turning maneuvers, particularly at high speeds. Your NISSAN four-wheel drive vehicle has a higher center of gravity than a passenger car. The vehicle is not designed for cornering at the same speeds as passenger cars. Failure to operate this vehicle correctly could result in loss of control and/or a rollover accident. ● Always use tires of the same type, size, brand, construction (bias, bias-belted, or radial), and tread pattern on all four wheels. Install tire chains on the rear wheels when driving on slippery roads and drive carefully. ● Be sure to check the brakes immediately after driving in mud or water. See "Brake system" later in this section for "Wet brakes". ● Avoid parking your vehicle on steep hills. If you get out of the vehicle and it rolls forward, backward or sideways, you could be injured. ● Whenever you drive off-road through sand, mud or water as deep as the wheel hub, more frequent maintenance may be required. See "Periodic maintenance" in the "NISSAN Service and Maintenance Guide." WARNING ● Never remove the ignition key or place the ignition switch in the LOCK position while driving. The steering wheel will lock (for models without Nissan vehicle immobilizer system). This may cause the driver to lose control of the vehicle and could result in serious vehicle damage or personal injury. WSD0041 AUTOMATIC TRANSMISSION The ignition lock is designed so the ignition switch cannot be placed in the LOCK position and the key cannot be removed until the shift selector is moved to the P (Park) position. When removing the key from the ignition switch, make sure the shift selector is in the P (Park) position. If the shift selector is not returned to P (Park) position, the ignition switch cannot be placed in the LOCK position. Starting and driving 5-9