2014 Nissan Frontier King Cab Owner's Manual - Page 150

WINDOWS Always evenly distribute the cargo on the tubular roof rack. The maximum total load is 125 lb (56 kg) evenly distributed. Be careful that your vehicle does not exceed the Gross Vehicle Weight Rating (GVWR) or the Gross Axle Weight Ratings (GAWR front and rear). The GVWR and GAWR are located on the F.M.V.S.S. label (located on the driver's side door jamb pillar). For more information regarding GVWR and GAWR, refer to "Vehicle loading information" in the "Technical and consumer information" section later in this manual. The front crossbar can be adjusted or removed. Use the Torxdriver provided in the tool kit to loosen both crossbar adjusting screws. To adjust: 1. Loosen the adjusting screws with the Torx1 by turning counterclockwise ᭺ A. driver ᭺ 2. When the clamp is loosened, move the crossbar so the cargo can be positioned on B. the crossbar ᭺ 3. Tighten the crossbar adjusting screws with the Torxdriver by turning clockwise. 4. Secure the cargo with rope. 5. Always check the tightness of the crossbar adjusting screws. To remove: 1. Loosen the adjusting screws with the Torx1 by turning counterclockwise ᭺ A. driver ᭺ POWER WINDOWS (if so equipped) WARNING ● Make sure that all passengers have their hands, etc. inside the vehicle while it is in motion and before closing the windows. Use the window lock switch to prevent unexpected use of the power windows. ● Do not leave children unattended inside the vehicle. They could unknowingly activate switches or controls and become trapped in a window. Unattended children could become involved in serious accidents. The power windows operate when the ignition switch is placed in the ON position, or for a period of time after the ignition switch is placed in the OFF position. If the driver's or passenger's door is opened during this period of time, the power to the windows is canceled. C. 2. Rotate the clamps ᭺ 3. Remove the crossbar. 4. Reverse to install. 5. Always check the tightness of the crossbar adjusting screws. If you hear wind noise coming from the roof rack while driving, adjust the roof rack crossbar to the neutral position, rearward of on the side rails. Instruments and controls 2-47