1995 Oldsmobile Silhouette Owner's Manual - Page 86

To manually close the power sliding door when the sliding door enable switch is in the ON position, pull the inside or outside latch release or the edge of the door. Move the door about four inchestoward the closed position and release. The door will close completely and latch for you. To manually close the power sliding door when the enable switch is in the OFF position, pull the inside or outside latch release and slide the door all the way forward to the latch position. On vehicles equipped with the optional power sliding door, a low voltage battery may cause the system to become inoperative. This is a built-in feature to prevent damage to the power sliding door motor. When the battery has been charged, follow these steps: 1. Make sure the door is in the closed position. 2. Turn the ignition off. 3. Remove the fuse marked TAIL from the fuse panel. 4. Wait 30 seconds. 5. Reinstall the fuse. 6. Cycle the door open and closed with either the wall mounted or overhead console switch. Wait three seconds before opening and closing the door again. If this does not restore power sliding door operation, see your retailer for service. 2-16