2006 Polaris Sportsman X2 500 EFI Owners Manual - Page 124

2006 Polaris Sportsman X2 500 EFI Manual

Page 124 highlights

TROUBLESHOOTING Engine Stops or Loses Power Possible Cause Out of fuel Kinked or plugged fuel vent line Water present in fuel Fouled or defective spark plug Worn or defective spark plug wires Incorrect spark plug gap or heat range Loose ignition connections Low battery voltage Incorrect fuel Clogged air filter Reverse speed limiter malfunction Electronic throttle control malfunction Other mechanical failure Overheated engine Solution Refuel Inspect and replace Replace with new fuel Inspect, clean and/or replace spark plug See your Polaris dealer Set gap to specs or replace plug Check all connections and tighten Recharge battery to 12.5 VDC Replace with recommended fuel Inspect and clean or replace See your Polaris dealer See your Polaris dealer See your Polaris dealer Clean radiator screen and core Clean engine exterior See your Polaris dealer Engine Overheating Possible Cause Debris lodged in screen Solution Remove and clean the screen. Pull on the top portion of the screen, then remove the lower portion. Use a garden hose to flush any debris from the radiator fins. NOTE: High pressure washers can deform the radiator fins and reduce cooling efficiency. Plugged Radiator 121

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136

121
TROUBLESHOOTING
Engine Stops or Loses Power
Possible Cause
Solution
Out of fuel
Refuel
Kinked or plugged fuel vent line
Inspect and replace
Water present in fuel
Replace with new fuel
Fouled or defective spark plug
Inspect, clean and/or replace spark plug
Worn or defective spark plug wires
See your Polaris dealer
Incorrect spark plug gap or heat range
Set gap to specs or replace plug
Loose ignition connections
Check all connections and tighten
Low battery voltage
Recharge battery to 12.5 VDC
Incorrect fuel
Replace with recommended fuel
Clogged air filter
Inspect and clean or replace
Reverse speed limiter malfunction
See your Polaris dealer
Electronic throttle control malfunction
See your Polaris dealer
Other mechanical failure
See your Polaris dealer
Overheated engine
Clean radiator screen and core
Clean engine exterior
See your Polaris dealer
Engine Overheating
Possible Cause
Solution
Debris lodged in screen
Remove and clean the screen. Pull on the
top portion of the screen, then remove the
lower portion.
Plugged Radiator
Use a garden hose to flush any debris
from the radiator fins.
NOTE:
High pres-
sure washers can deform the radiator fins
and reduce cooling efficiency.