2010 Polaris Sportsman 550 Touring EPS Owners Manual - Page 108
2010 Polaris Sportsman 550 Touring EPS Manual
Page 108 highlights
MAINTENANCE Lights High Beam Adjustment The headlight beam can be adjusted slightly upward or downward. Use the following procedure to make the adjustment. 1. Position the vehicle on a level surface with the headlight approximately 25 ft. (7.6 m) from a wall. Place the transmission in PARK. 25 ft. (7.6 m) Lamp Center Height 2" (5 cm) 2. Measure the distance from the floor to the center of the headlight and make a mark on the wall at the same height. 3. Start the engine.Turn the headlight switch to high beam. 4. Observe the headlight aim on the wall. The most intense part of the headlight beam should be two inches (5 cm) below the mark on the wall. Include rider weight on the seat when measuring. 5. The adjustment knob is Adjustment located on the right side of Screw the headlight pod. Adjust the beam to the desired position by turning the knob either clockwise or counter-clockwise. 104