2006 Pontiac Vibe Owner's Manual - Page 259
2006 Pontiac Vibe Manual
Page 259 highlights
Then, without shutting off the engine, follow these steps: The automatic transaxle dipstick has an orange handle and is located near the front of the engine compartment. See Engine Compartment Overview on page 5-12 for more information on location. 1. Release the tab and pull out the dipstick and wipe it with a clean rag or paper towel. 2. Push it back in all the way, wait three seconds and then pull it back out again. How to Add Automatic Transaxle Fluid Refer to the Maintenance Schedule to determine what kind of transaxle fluid to use. See Part D: Recommended Fluids and Lubricants on page 6-19. If the fluid level is low, add only enough of the proper fluid to bring the level into the area between dimples on the dipstick. 1. Pull out the dipstick. 2. Using a long-neck funnel, add enough fluid at the dipstick hole to bring it to the proper level. It does not take much fluid, generally less than one pint (0.5 L). Do not overfill. Notice: Use of the incorrect automatic transaxle fluid may damage your vehicle, and the damages may not be covered by your warranty. Always use the automatic transaxle fluid listed in Part D: Recommended Fluids and Lubricants on page 6-19. 3. After adding fluid, recheck the fluid level as described under "How to Check Automatic Transaxle Fluid," earlier in this section. 4. When the correct fluid level is obtained, push the dipstick back in all the way; then press the tab down to lock the dipstick in place. 3. Check both sides of the dipstick, and read the lower level. The fluid level must be between the two dimples in the hot range. 4. If the fluid level is in the acceptable range, push the dipstick back in all the way; then press the tab down to lock the dipstick in place. 5-23