2006 Subaru Baja Owner's Manual - Page 107

Keys and doors seconds. The alarm is triggered by: Opening a door Turning the ignition switch to the "ON" position Physical impact to the vehicle, such as forced entry (only vehicles with shock sensors (dealer option)) now activated. NOTE You may have the above setting change done by your SUBARU dealer. Activating and deactivating the alarm system To change the setting of your vehicle's alarm system for activation or deactivation, do the following. 1. Disarm the alarm system (see "Disarming the system" in this section). 2. Sit in the driver's seat and shut all doors. 3. Turn the ignition switch to the "ON" position. 4. Hold down the UNLOCK side of the driver's power door locking switch, open the driver's door within the following 1 second, and wait 10 seconds without releasing the switch. The setting will then be changed as follows: If the system was previously activated: The horn sounds twice, indicating that the system is now deactivated. If the system was previously deactivated: The horn sounds once, indicating that the system is 2-18 If you have accidentally triggered the alarm system To stop the alarm Do any of the following operations: Press any button on the remote transmitter. Cycle the ignition switch from the "LOCK" to "ON" position three times within 5 seconds. Arming the system Arming the system 1. 2. 3. 4. 5. To arm the system using remote transmitter Close all windows and the moonroof (if equipped). Remove the key from the ignition switch. Open the doors and get out of the vehicle. Make sure that the engine hood is locked. Close all doors.