2008 Subaru Tribeca Owner's Manual - Page 112

2-18 Keys and doors position. & Tripped sensor identification The security indicator light flashes when the alarm system has been triggered. Also, the number of flashes indicates the location of unauthorized intrusion or the severity of impact on the vehicle. . When the ignition switch is turned to the "ON" position, the indicator light will light for 1 second and then flash as follows: When a door or rear gate was opened: 5 times When the ignition switch was turned to the "ON" position by using a key not registered with your immobilizer system: 3 times When a strong impact or multiple impacts were sensed: twice (only vehicles with shock sensors (dealer option)) When a light impact was sensed: once (only vehicles with shock sensors (dealer option)) 1) 2) LOCK ON 2. Turn the ignition switch from "ON" to "LOCK" position and remove the key from the ignition switch. 3. Open the doors and get out of the vehicle. 4. Before closing the doors, lock all doors with the inside door lock levers. 5. Close the doors. The system will automatically arm after one minute. In the passive mode, the system can also be armed with the remote transmitter or with the power door locking switches. If the remote transmitter or power door locking switch is used to lock the vehicle, arming will take place immediately regardless of whether or not the passive mode has been selected. ! Disarming the system To disarm the system, briefly press the " " button on the transmitter. & Shock sensors (dealer option) The shock sensors trigger the alarm system when they sense impacts applied to the vehicle and when any of their electric wires is cut. The alarm system causes the horn to sound and the turn