2008 Subaru Tribeca Owner's Manual - Page 155
2008 Subaru Tribeca Manual
Page 155 highlights
Instruments and controls 3-35 When the wiper switch is in the " " position, turn the dial to adjust the operating interval of the wiper. The operating interval can be adjusted in nine steps. The intermittent operation interval varies depending on the vehicle speed in any of the adjustment steps (longer when the vehicle speed is low; shorter when the vehicle speed is high). ! Washer NOTE & Rear window wiper and washer switch The windshield washer fluid warning light comes on when the washer fluid level in the tank has dropped to the lower limit. If the warning light illuminates, refill the tank with fluid. For the tank refilling method, refer to the "Windshield washer fluid" section in chapter 11. To wash the windshield, push the washer button at the end of the wiper control lever. The washer fluid sprays until you release the washer button. The wipers operate while you push the button. : Washer (accompanied by wiper operation) ON: Continuous INT: Intermittent OFF: Park : Washer ! Rear wiper To turn the rear wiper on, turn the knob on the end of the wiper control lever upward to the "INT" or "ON" position. To turn the wiper off, return the knob on the end of the lever to the "OFF" position. With the switch turned to the "INT" position, the rear wiper will operate intermittently at intervals corresponding to the vehicle speed (longer when the vehicle - CONTINUED -