2009 Subaru Outback Owner's Manual - Page 109

Keys and doors 2-17 position. 4. Hold down the UNLOCK side of the driver's power door locking switch, open the driver's door within the following 1 second, and wait 10 seconds without releasing the switch. The setting will then be changed as follows: If the system was previously activated: For a vehicle without SI-DRIVE, the odometer/trip meter screen displays "AL oF", and for a vehicle with SI-DRIVE, the multi-information display shows "Security alarm: OFF" and the horn sounds twice, indicating that the system is now deactivated. If the system was previously deactivated: For a vehicle without SI-DRIVE, the odometer/trip meter screen displays "AL on", and for a vehicle with SI-DRIVE, the multi-information display shows "Security alarm: ON" and the horn sounds once, indicating that the system is now activated. & If you have accidentally triggered the alarm system ! To stop the alarm Do any of the following operations: . Insert the key in the door lock of the driver's door and turn it to the unlock position. . Press any button on the remote transmitter. . Turn the ignition switch to the "ON" position. & Arming the system ! To arm the system using remote transmitter 1. Close all windows and the moonroof (if equipped). 2. Remove the key from the ignition switch. 3. Open the doors and get out of the vehicle. 4. Make sure that the engine hood (and the trunk lid on the Sedan) are locked. 5. Close all doors (and the rear gate on the Station wagon). : Press to Arm the system. : Press to Disarm the system. NOTE You may have the above setting change done by your SUBARU dealer. Vehicle with SI-DRIVE - CONTINUED -