2009 Subaru Outback Owner's Manual - Page 276

7-30 Starting and operating when the vehicle is stopped in the "D" or "R" position. . Always set the parking brake when parking your vehicle. Do not hold the vehicle with only the transmission. . Do not keep the vehicle in a stationary position on an uphill grade by using the "D" position. Use the brake instead. . The engine may, on rare occasions, knock when the vehicle rapidly accelerates or rapidly pulls away from a standstill. This phenomenon does not indicate a fault. . A slight reduction in output torque may occur in the models with a 2.5 L turbo or 3.0 L engine before the engine warms up. 6. Remove the screwdriver from the hole. Depress the brake pedal and start the engine. Take your vehicle to the nearest SUBARU dealer immediately to have the system repaired. 3. Remove the cover by prying on the edge with a flat-head screwdriver. & Shift lock release If the selector lever does not move from the "P" position with the brake pedal depressed and the ignition switch in the "ON" position, perform the following steps: To override the shift lock: 1. Set the parking brake and stop the engine. 2. Take out the screwdriver from the tool bucket. 4. Insert the screwdriver into the hole. 5. Push down on the screwdriver and move the selector lever from the "P" to the "N" position.