2009 Suzuki Grand Vitara Owner's Manual - Page 126

OPERATING YOUR VEHICLE To reset the cruise control to a faster speed, use either of the following procedures: • Hold in the "RES/ACC" switch (4). Vehicle speed will steadily increase. When you release the switch, the new speed will be maintained. • Accelerate to the desired speed using the accelerator pedal and push the "SET/COAST" switch (3). The new speed will be maintained. To "Resume" a Previously Set Speed After canceling cruise control operation without turning off the "ON/OFF" switch (1), you can "resume" a previously set speed, by holding the "RES/ACC" switch (4) for about one second. When you release the switch, the vehicle will accelerate to and maintain the previously set speed. NOTE: If the "ON/OFF" switch (1) is turned off, the set speed in the memory is cleared and you can not use the Resume feature. In this case, reset your CRUISE speed. Braking To Cancel To cancel cruise control operation, use one of the following procedures: • Slightly depress the brake pedal or clutch pedal, or push the "CANCEL" switch (2). Cruise control operation will be canceled until you reset a cruising speed by pushing the "SET/COAST" switch (3) or "RES/ACC" switch (4). • Push the "ON/OFF" switch (1). Cruise control operation will be canceled until you turn on the system by pushing the "ON/OFF" switch (1) again and reset a cruising speed by pushing the "SET/ COAST" switch (3). Cruise control operation will also be canceled any time the vehicle speed falls below 40 km/h (25 mph). 60G165 The distance needed to bring any vehicle to a halt increases with the speed of the vehicle. The braking distance needed, for example, at 60 km/h (37 mph) will be approximately 4 times greater than the braking distance needed at 30 km/h (19 mph). Start to brake the vehicle when there is plenty of distance between your vehicle and the stopping point, and slow down gradually. 3-27 79K20-03E