2010 Suzuki Kizashi Owner's Manual - Page 140

OPERATING YOUR VEHICLE CVT - If the gearshift lever is not in the "P" (Park) position, shift it to "P". Hold the brake pedal fully depressed. 3) The PUSH START SWITCH. message will appear on the information display in the instrument cluster. Press the engine switch (1). 4) Within about 10 seconds of flashing of the master warning light in the instrument cluster, touch the engine switch with the lock switch end of the remote controller (2) for about 2 seconds. NOTE: • If you still cannot start the engine after several attempts using the above method, there may be a problem elsewhere, such as a low battery. Contact your SUZUKI dealer for inspection. • The immobilizer/keyless start system warning light will light for about 5 seconds while the master warning light is flashing. In addition, the information display will show a certain message during this time. Refer to "Information Display" in the "Before Driving" section for details. • You may customize the system to cause the interior buzzer to sound once for the "remote controller out of sensing range" warning. Please contact an authorized SUZUKI dealer for the customization. • If the battery of the remote controller is about to be completely discharged, a message warning this will appear on the information display when the ignition mode is changed to "ON" by pressing the engine switch. For details on replacing the battery, refer to the "Keyless Start System Remote Controller" section in the "Before Driving" chapter. - Disconnect the negative cable from the battery to prevent discharge. "LOCK" (OFF) mode reminder buzzer If the driver's door is opened without returning the ignition mode to "LOCK" (OFF) by pressing the engine switch, a buzzer sounds to warn you of this state. • If you open the driver's door after pressing the engine switch to change the ignition mode to "ACC", the interior buzzer beeps intermittently. • The buzzer will stop sounding if you then push the engine switch twice, thus bringing it back the ignition mode to "LOCK" (OFF). NOTE: Whenever you leave the vehicle, make sure you have returned the ignition mode to "LOCK" (OFF) using the engine switch and then lock the doors. Without returning the ignition mode to "LOCK" (OFF), you cannot use a request switch or keyless start system remote controller to lock the doors. Returning the ignition mode to "LOCK" (OFF) CVT - To ensure safety, the ignition mode can be returned to "LOCK" (OFF) by pressing the engine switch only when the gearshift lever is placed in the "P" position. NOTE: • Messages may appear on the information display in the instrument cluster when you attempt to return the ignition mode to "LOCK" (OFF) by pressing the engine switch. Refer to "Information display" in the "Before Driving" section for details. • In the case of a CVT model, the engine cannot be returned to the "LOCK" (OFF) position if the gearshift lever is in any other position than "P". Certain problems like a fault in engine system may prevent the engine switch from going back to the "LOCK" (OFF) mode. If this happens, have the vehicle inspected by an autohorized SUZUKI dealer after doing the following: - Lock the doors using the key to prevent theft. (The request switches and the keyless start system remote controller cannot be used to lock them.) 3-9