2001 Volvo S40 Owner's Manual - Page 47

2001 Volvo S40 Manual

Get 2001 Volvo S40 PDF manuals and user guides View all 2001 Volvo S40 manuals

Page 47 highlights

Remove cover Removing high/low beam headlight bulbs · Your car is fitted with separate high and low beam bulbs. · Switch off the lights and remove the ignition key. · Open the hood. · Pull off the rubber cover from the rear of the bulb unit to be replaced. · Release the retaining spring and withdraw the connector/bulb from the headlight unit. Pull the bulb out of the connector. NOTE: Never touch the glass of a bulb with your fingers: this could leave traces of grease or oil on the glass which then evaporate and may damage the reflector. pg. 88 Replacing bulbs Installing high/low beam headlight bulbs · Insert the new bulb in the headlight unit · Reconnect the connector and wiring. · Press the retaining spring over the connector/bulb until it clicks into position. · Reinstall the rubber cover at the rear of the headlight unit. · Put the hard plastic cover in place above the headlight housing and press the tab down to secure the cover.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
Remove cover
Removing high/low beam headlight bulbs
· Your car is fitted with separate high and low beam bulbs.
· Switch off the lights and remove the ignition key.
· Open the hood.
· Pull off the rubber cover from the rear of the bulb unit to be replaced.
· Release the retaining spring and withdraw the connector/bulb from the headlight unit. Pull the bulb out of the
connector.
NOTE: Never touch the glass
of a bulb with your fingers: this could leave traces of grease or oil on the glass which
then evaporate and may damage the reflector.
pg. 88 Replacing bulbs
Installing high/low beam headlight bulbs
· Insert the new bulb in the headlight unit
· Reconnect the connector and wiring.
· Press the retaining spring over the connector/bulb until it clicks into position.
· Reinstall the rubber cover at the rear of the headlight unit.
· Put the hard plastic cover in place above the headlight housing and press the tab down to secure the cover.