2008 Volvo C30 Owner's Manual - Page 110

(indicated by the arrow in the inset illustration). 2. Insert the key blade as far as possible in the driver's door lock. Turn the key blade clockwise approximately one quarter turn to unlock the driver's door only. This will trigger the alarm. 3. To disable the alarm: Press the Unlock button on the keyless drive remote control. If the batteries in the remote are weak, remove the keyless drive start control from the ignition switch by pressing the catch (see the illustration on page 143) and pulling the control out of the ignition switch. Insert the ignition key section of a keyless drive remote control in the ignition switch. NOTE The number of doors that are unlocked at the same time can be set in the Personal settings menu. See page 78 for additional information. If one or more doors and/or the rear liftgate is not fully closed when the lock button is pressed, the door(s) or rear liftgate will not be locked. On keyless drive vehicles with an automatic transmission, the gear selector must be in the Park ( P) position and the ignition must be switched off before the doors/trunk can be locked. Keyless drive remote control and driver's seat memory This function is only available on vehicles equipped with the optional power driver's seat. When you leave the vehicle with a keyless drive remote control in your possession and lock any door, the position of the driver's seat will be stored in the seat's memory. The next time a door is opened by a person with the same remote control in his/her possession, the driver's seat will automatically move to the position that it was in when the door was most recently locked. NOTE If several people carrying keyless drive remote controls approach the vehicle at the same time, the driver's seat will assume the position it was in for the person who opens a door first. Keyless drive information messages If anyone leaves the vehicle with the only keyless drive remote control in his or her possession while the ignition is switched on, 124 05 Locks and alarm Keyless drive (option as available) a message will be shown in the information display and an audible signal will sound. NOTE This message will only be displayed if the start control is in position I or II. The message will be erased from the display and the audible signal will stop when the remote control has been returned to the vehicle and one of the following has occurred: A door has been opened and closed The start control has been turned to position 0 The READ button (see page 56 for the location of this button) has been pressed.