2010 Volvo XC60 Owner's Manual - Page 279

06 Maintenance and specifications Vehicle care CAUTION gent. For best protection in winter, Volvo recommends the use of Volvo rubber floor mats. Consult your Volvo retailer. Paint repairs require special equipment and skill. Contact your Volvo retailer for any extensive damage. Minor scratches can be repaired by using Volvo touch-up paint. • Under no circumstances should gasoline, naphtha or similar cleaning agents be used on the plastic or the leather since these can cause damage. Take extra care when removing stains such as ink or lipstick since the coloring can spread. Use solvents sparingly. Too much solvent can damage the seat padding. Start from the outside of the stain and work toward the center. Sharp objects (e.g. pencils or pens in a pocket) or Velcro fasteners on clothing may damage the textile upholstery. Clothing that is not colorfast, such as new jeans or suede garments, may stain the upholstery. Spots on interior plastic, metal, or wood surfaces Cleaning interior plastic components should be done with a cleaning agent specially designed for this purpose. Consult your Volvo retailer. Color code Make sure you have the right color. The color code number is stated on the model plate. Minor stone chips and scratches Touching up paintwork Material: Primer - can Paint - touch-up pen Brush Masking tape Cleaning the seat belts Clean only with lukewarm water and a mild soap solution. If the stone chip has not gone down to the bare metal and an undamaged color coat remains, you can add paint immediately after removing dirt. 06 NOTE Paint code on the model plate1 Cleaning floor mats The floor mats should be vacuumed or brushed clean regularly, especially during winter when they should be taken out for drying. Spots on textile mats can be removed with a mild deter1 Paint damage requires immediate attention to avoid rusting. Make it a habit to check the finish regularly, for instance washing the vehicle. Touch-up if necessary. When touching up the vehicle, it should be clean and dry. The surface temperature should be above 60 °F (15 °C). see page 281 for the location of the model plate. `` 279