2013 Volvo S60 Owner's Manual - Page 114

03 Your driving environment HomeLink® Wireless Control System* NOTE If the ignition is switched off, HomeLink will function for 30 minutes after the driver's door has been opened. 03 Reprogramming a Single HomeLink Button To program a device to HomeLink using a HomeLink button previously trained, follow these steps: 1. Press and hold the desired HomeLink button. DO NOT release the button. 2. The indicator light will begin to flash after 20 seconds. Without releasing the HomeLink button, proceed with "Programming" - step 1. For questions or comments, contact HomeLink at: www.homelink.com or phone 1-800-355- 3515. This device complies with FCC rules part 15 and Industry Canada (IC) RSS-210. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference that may be received including interference that may cause undesired operation. NOTE The transmitter has been tested and complies with FCC and IC rules. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the device.2 Resetting HomeLink Buttons Use the following procedure to reset (erase programming) from the three HomeLink buttons (individual buttons cannot be reset but can be "reprogrammed" as outlined in the following section): 1. Press and hold the two outer HomeLink buttons until the indicator light begins to flash. 2. Release both buttons. > HomeLink is now in the training (or learning) mode and can be programmed at any time beginning with "Programming" - step 1. 2 The term "IC:" before the certification/registration number only signifies that Industry Canada technical specifications were met. 112 * Option/accessory, for more information, see Introduction.