2006 Yamaha Motorsports Attak Owners Manual - Page 66
2006 Yamaha Motorsports Attak Manual
Page 66 highlights
8. Install the engine oil drain bolts, and then tighten them to the specified torques. Tightening torques: Crankcase engine oil drain bolt: 30 Nm (2.6 m·kgf, 3.2 ft·lb) Oil tank engine oil drain bolt: 16 Nm (1.6 m·kgf, 11 ft·lb) 9. Add 2.0 L (1.8 Imp qt, 2.1 US qt) of the recommended engine oil to the oil tank, and then install and tighten the oil level gauge/dipstick. Recommended engine oil: See page 6-2. Oil quantity: With oil filter cartridge replacement: 3.0 L (2.6 Imp qt, 3.2 US qt) Without oil filter cartridge replacement: 2.8 L (2.5 Imp qt, 3.0 US qt) Total amount: 3.8 L (3.3 Imp qt, 4.0 US qt) 10. Start the engine, warm it up for several minutes, and then turn it off. 11. Add sufficient oil of the recommended type to raise it to the "F" level mark on the oil level gauge/dipstick. (See pages 6-3-6-4 for the checking procedures.) CAUTION: @ G G @ When adding the engine oil, be careful not to fill above the "F" level mark on the oil level gauge/ dipstick. Make sure that no foreign material enters the engine oil tank. 12. Start the engine, and then let it idle for several minutes while checking it for oil leakage. If oil is leaking, immediately turn the engine off and make sure that the engine oil drain bolts and oil level gauge/dipstick are installed correctly. 13. Turn the engine off, and then connect the oil level gauge coupler. 8-13